Product Details

Induced Withstand Voltage Test Device Instructions:

1. According to the debugging requirements, connect the current booster and the test object, and connect the power supply.

2. Select the position of the current transfer switch based on the current required by the test object. Since the current transformer does not allow open circuit, the current transfer switch can only be set to "High" or "Low" position, and cannot be placed in the middle position.

3. Close the power supply, the green light will turn on (if the green light does not turn on, turn the voltage regulator knob counterclockwise to zero until the green light turns on), press the start button, the green light turns off and the red light turns on, rotate the voltage regulator handle clockwise to raise the current to the required value.

4. Turn the voltage regulator handle counterclockwise to zero, press the stop button, the red light turns off and the green light turns on, the test is completed.

Induced Withstand Voltage Test Device Completeness

1. Current booster main unit               One set

2. Product certificate               One copy

3. Product instruction manual             One copy

Electrical Parameters

Input voltage: Three-phase 380V    50Hz

Output voltage: 600V    150Hz

Waveform: Sine wave, distortion less than 1%

Capacity: 15KVA

Load characteristics: Resistive, inductive, capacitive all acceptable

Induced Withstand Voltage Test Device Precautions:

1  When opening the box, check the integrity of the equipment and the insulation condition of the main circuit and control circuit. The resistance should not be less than 0.5MΩ.

2  Before use, check whether the connections at each joint are loose, especially the contact of the voltage regulator carbon brush should be good.

3  When not used for a long time, store in a dry place without corrosive gases.